User`s manual
2
Basic
Operation
Outputting
59
How to Perform a Normal cleaning
Procedure
Press .
Press to display the left gure.
Press
, and then .
Press .
Normal cleaning starts.
When it nishes, the screen shown in the gure appears again.
Press to go back to the original screen
Perform a printing test again to make sure the dot drop-out has been corrected.
If the problem persists, try performing cleaning a second time. If the printer has been used for a long
period, the problem may persist even after two or three-cycle cleaning. Then try cleaning using a dier-
ent method.
P. 74, "When Normal Cleaning Is Not Effective"
Important Note on Cutting
When you’re performing cutting only, never use the media clamps.
When you’re performing cutting only, remove the media clamps or move to the locations where they don’t
clamp the media.
FUNCTION
CLEANING
CLEANING
NORMAL
CLEANING...
>>
CLEANING
NORMAL
W1200mm
SETUP SHEET