User`s manual

Basic

Operation

Outputting



Peel off the cut shapes to verify the cutting quality.

[Two shapes are peeled off separately]

You do not need to perform the setting because the blade

force is appropriate.

[Two shapes are peeled off together/backing paper

is also cut]

Go to the next Procedure to set the blade force.

Setting the blade force.



Press .



Press .



Press to select the value.

[Two shapes are peeled off together]

Raise the blade force.

[Backing paper is also cut]

Reduce the blade force.

Press to enable the setting.



Press to go back to the original screen.

At the [CUT CONFIG] menu, you can also make settings for other cutting conditions in addition to the blade

force. Refer to the following pages.

 P. 115, "Fine-tuning the Cutting Conditions"

FUNCTION

CUT CONFIG

FORCE

50 gf 60 gf

W1200mm

SETUP SHEET

Rectangle

Circle