User`s manual

2
Basic Operation
Outputting
65

Press .
The media is cut o.
You can make the setting in the software RIP for automatic media cuto after printing or cutting has
nished. For information on how to make the setting, refer to the documentation for the software RIP
you're using.
Cut-off Operations
 Be sure to detach the media clamps. Performing cuto with the media clamps remaining attached
may cause the operation to be interrupted due to detection of the media clamps.
 If the media clamps are present on the machine when the setting to execute automatic cuto of
the media is made on the computer, the media clamps are detected and no cuto operation is
performed
 Before you're performing cuto, never use to pull the media back. Unless the end of the
media has been pulled out to a location to the front of the platen, cuto may not be performed
smoothly.
Give Attention to Media Composition
 For some types of media, cuto is not possible.
 Some types of media may remain on the platen after cuto. If the media remains on the platen,
remove it by hand.
Blade protector Blade protector
Printed
portion
The media is fed
The media is
cut off here.