User`s manual

Replacing Consumable Parts
3
Maintenance
91

Replace the blade.

Support the screw from below and insert
the blade holder.
If installed without supporting the screw in this way,
cutting quality may become poor.

Tighten the screw.
Tug the blade holder upward to make sure it does
not come loose.
3. Quit the blade replacement menu.

Close the front cover.
Press
.

Press to go back to the original screen.
4. Adjusting the Cutting Conditions and Cutting-in Amount.
 P. 115, "Fine-tuning the Cutting Conditions,” p. 117, "Accurately Adjusting the
Cutting-in Amount"
W1200mm
SETUP SHEET
Remove the old
blade.
Press this
pin.
Old blade
Install a new blade.
Pin
New Blades
Screw
Insert until the collar is
ush with the surface.