User Manual

click “Firmware.” NOISE will look for BLOCKS updates. If there are new
firmware updates, you may select “Click to Update.” The update will take a few
minutes to process. When the update is finished, your Block will restart. After
your Block restarts, reconnect it to NOISE by clicking “OK” and then clicking on
the name of your Block.
Lightpad Blocks need at least 30% battery remaining in order to update the
firmware. If you are not able to update your Block’s firmware, make sure it is
charged and try again.
Re-Connecting to NOISE
To re-connect your Blocks to NOISE after the initial setup please follow the
steps below:
Turn Bluetooth ‘ON’ on your iOS device.
Turn on the Lightpad Block by pressing the power button.
The Lightpad Block will power up in Bluetooth pairing mode as long as it is
not connected by cable to a computer. This is indicated by a blue light on
the power button and an expanding blue ring displayed on the Lightpad
Surface. If there is no blue light then please press the power button once
to enter pairing mode.
Launch NOISE on your iOS device.
Press the Bluetooth icon in NOISE and select ‘Lightpad Block XXX’ from the
list of Bluetooth MIDI Devices to pair app and hardware.
4 Learn