User Manual

Notes toggle to “OFF”. Press the “X” at the top right-hand corner of the
screen to exit back to Instrument View. Press the Chord Button and
turn it on. Select “Octave” and then “X” to exit. Now press the Arp
Button. Turn it “ON”, set Pattern to “Up”, Gate to 80%, Time to 1/16,
and Octave to “2”. Press “X” to exit. Now when you play one of the
pads on the Lightpad Block you will hear a steady and instant bass
line.
Swipe back down to Song View and touch the left-most loop slot in the
2nd row from the top on the Lightpad Block (Instrument 2). This slot is
now record enabled. Touch it again to return to Instrument View. Press
the Record Button and begin recording after the 1 bar count-in. Strike
and hold a note for 1 bar before changing to a new note. Continue for
4 bars. Now you have recorded an animated bass line just by playing 4
notes.
Add Some Chords
Select the next Solo Instrument and switch the preset to “Digital Glass
Synth”. Turn on Chord and set it to “5th”. Select the first loop slot in
this instrument and press record. After the count in play the same
notes and durations as you did for the bassline.
Add A Melody
Select the last instrument and switch to the preset “Moraz Lead”. Add
an Arp if you wish or just experiment with the 5 Dimensions of Touch.
Select the bottom left loop slot on the Lightpad Block and press it
again to return to Instrument View. Press record and play, adding lots
of 5D Touch. NOISE will record all of your movements.