User manual

UserManualofNetworkCamera
51
5.6.6 EmailSendingTriggeredbyAlarm
Purpose:
The system can be configured to send an Email notification to all designated
receivers if an alarm event is detected, e.g., motion detection event, video loss,
tamper‐proof,etc.
Beforeyoustart:
PleaseconfiguretheDNSServersettingsunderBasicConfiguration>Network>
TCP/IPorAdvancedConfiguration>Network>TCP/IPbeforeusingtheEmail
function.
Steps:
1. Enterthe
TCP/IPSettings(Configuration>BasicConfiguration>Network>TCP/IPor
Configuration>AdvancedConfiguration>Network>TCP/IP)tosettheIPv4
Address,IPv4SubnetMask,IPv4DefaultGatewayandthePreferredDNSServer.

PleaserefertoSection5.3.1ConfiguringTCP/IPSettingsfordetailedinformation.
2. EntertheEmailSettingsinterface:
Configuration>AdvancedConfiguration>Events>Email

Figure5‐36 EmailSettings
3. Configurethefollowingsettings:
Sender:Thenameoftheemailsender.