User manual



Appendix2PortMapping
ThefollowingsettingsareforTP‐LINKrouter(TL‐R410).The settingsvarydepending
ondifferentmodelsofrouters.
Steps:
1. SelecttheWANConnectionType,asshownbelow:

FigureA.2.1SelecttheWANConnectionType

2. Set the LAN parameters of the router as in the following figure, including IP
addressandsubnetmasksettings.

FigureA.2.2SettheLANparameters

3. SettheportmappinginthevirtualseversofForwarding.Bydefault,camerauses
port80,8000,554and8200.Youcanchangetheseportsvaluewithwebbrowser
orclientsoftware.
Example:
Whenthecamerasareconnectedtothesamerouter,youcanconfiguretheports
of a camera as 80, 8000, 554 and 8200 with IP address 192.168.1.23, and the