User manual

UserManualofNetworkCamera
8
Chapter2 NetworkConnection
Beforeyoustart:
 If you want to set the network camera via a  LAN (Local Area Network), please
refertoSection2.1SettingtheNetworkCameraovertheLAN.
 Ifyouwantto setthe network cameravia aWAN (WideArea Network),please
refertoSection2.2SettingtheNetworkCameraovertheWAN.
2.1 SettingtheNetworkCameraovertheLAN
Purpose:
To view and configure the camera via a LAN, you need to connect the network
camerainthesamesubnetwithyourcomputer,andinstalltheiVMS‐4200software
tosearchandchangetheIPofthenetworkcamera.

Forthedetailedintroducti on ofiVMS‐4200,pleaserefertoAppendix1.
2.1.1 WiringovertheLAN
The following figures show the two ways of cable connection of a network camera
andacomputer:
Purpose:
 Totestthenetworkcamera,youcandirectlyconnectthenetworkcameratothe 
computerwithanetworkcableasshowninFigure2‐1.
 RefertotheFigure2‐2tosetthenetworkcameraovertheLANviaaswitchora
router.

Figure2‐1 ConnectingDirectly