User manual

User Manual of Network Camera
72
5. You can copy the settings to other alarm outputs.
6. Click Save to save the settings.
Figure 6-42 Alarm Output Settings
6.6.5 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the cameras.
Steps:
1. Enter the Exception Settings interface:
Configuration > Advanced Configuration> Events > Exception
2. Check the checkbox to set the actions taken for the Exception alarm. Refer to
Task 3 Set the Alarm Actions Taken for Motion Detection in Section 5.6.1.
Figure 6-43 Exception Settings
3. Click Save to save the settings.
6.6.6 Configuring Face Detection
Note: The face detection is only supported by a certain series of camera modes. Check
the specification for whether the module supports the function.
If you enable the face detection, once a face appears in the surveillance area, it will be