User manual

User Manual of Network Camera

A<->B: Only the arrow on the B side shows; when an object going across the plane

with both direction can be detected and alarms are triggered.

A->B: Only the object crossing the virtual plane from the A side to the B side can be

detected.

B->A: Only the object crossing the virtual plane from the B side to the A side can be

detected.

5. Set the sensitivity [1~100].

6. Choose another virtual plane on the dropdown list to configure. Up to 4 virtual

planes are configurable.

7. Click Edit to edit the arming schedule for traversing virtual plane detection. The

arming schedule configuration is the same as the setting of the arming schedule

for motion detection. Refer to Task 2 Set the Arming Schedule for Motion

Detection in Section 5.6.1.

8. Check the checkbox to select the linkage method taken for the traversing virtual

plane. Please refer to Task 3 Set the Alarm Actions for Motion Detection in

Section 5.6.1.

9. Click Save to save the settings.

6.6.9 Configuring Intrusion Detection

Intrusion detection can set an area in the surveillance scene and once the area is been

entered, a set of alarm action is triggered.

Steps:

1. Check the Enable Intrusion Detection checkbox.

2. Check the Enable Dual-VCA checkbox. The event information will be recorded

in the video stream, and you can search it out via smart search function during

playback on the Hybrid DVR / NVR.

3. Click Draw Area, and then draw a rectangle on the image as a defense region.

Note: when you draw the rectangle, all lines should connect end to end to each

other. Up to four areas are supported.