User manual

User Manual of Network Camera
77
Figure 6-47 Intrusion Detection Settings
You can click Clear to clear the areas you drawn.
The defense region parameters can be set separately.
4. Choose the region to be configured.
 Threshold: Range [0-10s], the threshold for the time of the object loitering in
the region. If you set the value as 0, alarm is triggered immediately after the
object entering the region.
 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the
object which can trigger the alarm, when the sensitivity is high, a very small
object can trigger the alarm.
 Percentage: Range [1-100]. Percentage: Range [1-100]. Percentage defines
the ratio of in-region object to the whole intrusion region, which can trigger
the alarm. For example, if you set the percentage as 50%, when the object
accounts 50% proportion of the region, the alarm is triggered.
5. Click Edit to edit the arming schedule for intrusion detection. The arming
schedule configuration is the same as the setting of the arming schedule for
motion detection. Refer to Task 2 Set the Arming Schedule for Motion Detection
in Section 5.6.1.