INSTALLATION GUIDE CARGO MANAGER® August 17, 2009
HARDWARE & COMPONENTS INCLUDED x 9 pieces #10-24 X 1/2" Truss Head Screw, for attachment of Tram Plate assembly and attachment of Tracks to RNL Tracks x 8 pieces Threaded Tangs (cargo nuts), for attachment of Tracks to RNL Tracks x 1 piece #10-24 Hex Nut, used for Tram Plate assembly x 1 piece Delrin wheel, for Tram Plate assembly x 1 piece 5/16" x 3/8" SS Shoulder Bolt, for Tram Plate assembly x 1 piece 1/4-20 Lock Nut, used for Tram Plate assembly x 1 piece #10 Lock Washer, used for Tram Plate assembly
IMPORTANT INFORMATION FOR "RIGHT SIDE STEERING TRUCKS" All assembly details shown herein are for “Left Side Steering” trucks. If you are doing an install on a “Right Side Steering” truck, the following components in Diagrams 2 & 3 should be assembled opposite of the way they are shown in these diagrams. I. The “Divider” should be reversed with the Control Levers on the right side, not the left as shown. II. The “Gusset Bracket” should be attached to the Right Side Tram Plate, not the left as shown. III.
STEP 2: ASSEMBLE THE TRAM PLATES (CONTINUED) B. Assemble the passenger’s side Tram Plate (Diagram 3). C. Slide the Tram Plates onto the ends of the Cargo Manager Divider and secure the stem locking screw on the driver’s side, being sure Diagram 3 that the screw enters the hole in the stem. Note: Do not place the screw in the passenger’s side. STEP 3: INSTALL A. THE ASSEMBLED CARGO MANAGER Install the assembled Cargo Manager divider into the Tracks.