User Instructions

8 | Automate
™
Programming Instructions | Motion Sensor ROLLEASE ACMEDA
1 STATIC TITLE
ROLLEASE ACMEDA | AUSTRALIA
110 Northcorp Boulevard,
Broadmeadows VIC 3047
T [phone] | F [phone]
ROLLEASE ACMEDA | USA
750 East Main Street, 7th Floor,
Stamford, CT 06902 6320
T [phone] | F [phone]
ROLLEASE ACMEDA | EUROPE
Via Conca Del Naviglio 18, Milan
(Lombardia) Italy
T [phone] | F [phone]
[e-mail]
rolleaseacmeda.com
Problem Cause Remedy
Sensor does not work
Battery is discharged Replace battery
Battery is inserted incorrectly Check battery polarity
Motor is not responding
Radio interference / Shielding
Ensures sensor is positioned away
from metal objects and that aerial
on motor is kept straight and away
from metal
Receiver distance is too far from
transmitter
Move sensor to a closer position
Power failure
Check power supply to motor is
connected and active
Incorrect wiring
Check wiring is connected
correctly (refer to motor
installation instructions)
Pairing error
Set dial to 5 or 9 and press multi
function button to verify motor
reacts
Awning constantly retracts during
operation
Sensitivity set too high Reduce sensitivity
Awning does not react to wind
setting
Wind Sensitivity is too high Adjust sensitivity
Duration of wind intensity level is
less than 3 seconds
Wind gust durations must be over
3 seconds to trigger
Sensor causes awning to extend
instead of retract
Direction is incorrect
Use remote to delete existing
upper/lower limits, hold UP and
DOWN button to reverse direction,
then set the upper/lower limits
again
Sensor beeps every five seconds Flat batteries Replace batteries with correct type
4 TROUBLE SHOOTING