User manual

Turn Power On

Slide the power button to „ON“ to turn on the

ﬂash and slide the button back to „OFF“ to turn

off the device.

In order to save battery power and avoid battery

leakage, the default settings are:

If the Flash Unit is turned on, but is not used

within 60 seconds, the ﬂash will automatically go into standby. The ﬂash can

be awaken by pressing any button. If the Flash Unit is not used for more than

30 minutes, the ﬂash will automatically shut down.

If the Flash Unit will not be used for a long period of time it is recommended to turn

it off by the power switch and remove the batteries. Before removing the batteries

please make sure that the ﬂash is turned off.

If the Flash Unit‘s capacitor is fully charged, the ﬂash key button will light up, which

indicates that the ﬂash is ready to trigger.

State of Charge Indicator

Please make sure that the ﬂash key button is

shining before using the ﬂash.

Use PC Sync to sync this ﬂash by cable with the

camera.

USB Port for upgrading latest version of program.