User manual

Flash exposure bracketing (FEB)

By using FEB the ﬂash exposure will be automatically changed, which helps in

conditions of invariable background exposure. You can take three ﬂash shots while

automatically changing the ﬂash output according to 1/3 to plus or minus.

After the FEB is done, the ﬂash will go back to the standard settings that have been

used before. (This can be turned off in the custom settings.)

For using FEB set your camera into the mode “single shot” and ensure that the ﬂash

is ready. Connect the Canon camera and set on the ﬂash exposure value surrounded

exposure.

If a Nikon camera is connected the ﬂash exposure information will not be shown of

the ﬂash. You need to refer to the camera set.

FEB Setting Surrounded by Exposure Value

(effective for Canon cameras only)

Press the “Parameter Settings Button“ to enter the setting by the current exposure

value.

1. The exposure value can be adjusted by the dial.

Rotate it clockwise to increase or counterclock-

wise to decrease the exposure value .

2. The exposure value has a range of 0 to 3.0. The

values are: 0 1 1.3 1.7 2.0 0.3 0.7 2.3 2.7 3.0

0 0.3 0.7 1.0 1.3 1.7 2.0 2.3 2.7 3.0