User manual

ENGLISH

Manual Wireless MASTER Unit

(M, Manual, MASTER, Canon)

Press the [Flash mode select button] to set the MASTER light as manual mode on

the MASTER unit. You can set up each slave unit in different ﬂash light ratios. Using

the MASTER unit to ﬁnish all settings (SLAVE unit and MASTER unit is the same).

1. Press the [Parameter setting button] for a long

time to set up the Canon MASTER unit Ratio.

2. Press down the [Flash mode select button] to

set up M mode.

3. Press down the [Wireless Parameter select

button] so often until RATIO twinkles.

4. Select the ﬂash light ratio. Rotate the dial to set the ﬂash light ratio:

<RATIO>, <RATIO A: B> or <RATIO A: B: C>. Select the ﬂash light ratio

<RATIO>. This means three SLAVE units will take the same mode and power

output with the MASTER. Press M mode to set the power output : Select the

ﬂash light ratio <RATIO A: B>. This means group A/B will ﬂash and the power

output of the ﬂashes in group A/B will be adjusted on the single ﬂashes. Select

the ﬂash light ration <RATIO A: B: C>. This means three groups are all on and

the power output can be adjusted on all single ﬂashes.

5. Set the ﬂash output <RATIO A:B> or <RATIO A:B:C>

Press the [Parameter setting button] until SLAVE account A and group A power

twinkles. Rotate the dial to adjust group A power.

Press the [Parameter setting button] until SLAVE account B and group B power

twinkles. Rotate the dial to adjust group B power.

Press the [Parameter setting button] until SLAVE account C and group C power

twinkles. Rotate dial to adjust group C power.