User manual

88
ENGLISH
Automatic Save Function
After flash has been set up, but for 5 seconds no buttons are pressed, the flash will
automatically save the current settings. It is convenient for next time operation.
Reset All Settings to Factory Default Settings
If you need to clear the changes on the flash,
restore the factory default settings. Therefore press
the "parameter settings button" and "High speed
/Rear curtain/Ordinary flashlight switch button”
at the same time. Then the flash will restore the
default settings.
Flash Lock (Low Power Tips)
When the battery power is low or other reasons
cause flash charging is not completed within the
time limit, the flash will enter a state of lock.
Meanwhile the screen shows a battery sign like
shown in the figure and it will make signal tone
that reminds the user to replace the battery.
Bounce Flash
If the flash head is pointed to the wall or ceiling, the flash will be reflected by the
wall. If this is illuminating then the subject, this can help to reduce shadows around
the subject and get more natural effects.