Operation Manual

Introduction Getting Ready Taking Pictures Playback Set Up
GB-143
Viewing Still Images | Viewing Movies | [o] Viewing Images Automatically as a Slideshow (slideshow) | [O] Viewing Multiple Images | [INFORMATION] Viewing Image Information | [J]/[I] Erasing Unwanted
Images | [U] Protecting Images from Accidental Erasing (PROTECT) | [p] Adding Voice Messages to Still Images (POSTRECORDING) | [V] Resizing and Trimming Images (RESIZE) | [W] Rotating an Image |
[T] Using DPOF to specify print settings | [G] Printing by Connecting the Camera Directly to a Printer (PictBridge) | Connecting to a Windows PC | Connecting to a Macintosh
NEXTBACK
Contents (Top page) Detailed Contents Index Nomenclature Menus and Settings Troubleshooting
Deleting the Device (Windows 98 and Windows 98SE only)
If the driver software is not installed successfully, the PC will be unable to
recognize the camera.
If this occurs, use the procedure below to delete the device. Then use the
procedure on p.136
to re-install the drivers.
* Note that this procedure is only required for Windows 98 and Windows
98SE.
1 Insert the memory card into the camera.
(Æ
p.21)
2 Load batteries into the camera.
3 Connect the camera to your PC using the USB cable provided
and then start up the PC.
A Important
Check the size of the USB connectors. Plug the small connector into the camera and
the large connector into the USB port on your PC.
Downloaded from www.Manualslib.com manuals search engine