Manualshelf

Full Product Manual

ManualsBrandsROLLICOOL ManualsAir ConditionersAlexa-Ready 14,000 BTU (7,500 BTU, DOE) Portable A/C and Dehumidifier Wi-Fi Enabled with App and Voice Control in White
11121314151617181920
15
RolliBot RolliCOOL 100H-20 Portable AC User Manual
• TurningonthetimermodewhentheunitisOFFwillsetthenumberofhoursbeforetheunitwillturnon(seebelow).
• TurningonthetimermodewhentheunitisONwillsetthenumberofhourstheunitwillturno(seebelow).
• Aftersettingthetimer,theACunitwillentertimermode.Whileinthismode,theunitwilloperateaccordingtothe
selected timer duration. Pressing the timer button again will turn timer mode o and cancel any duration setting.
To Set a Turn On Time
1. When the unit is OFF, press the timer button on the control panel.
2. Use the up and down buttons to select the time the AC unit will turn on. For example,
selecting “03” will prompt the unit to turn on in 3 hours.
3. After the selection is complete, the display’s Timing light will turn on.
When a schedule is active, the unit will not turn on if the chosen temperature is higher than the indoor temperature.
To Set a Shut off Time
1. When the unit is ON, press the timer button on the control panel.
2. Use the up and down buttons to select the time the AC unit will turn o. For example,
selecting “03” will prompt the unit to turn o in 3 hours.
3. After the selection is complete, the display will show the current indoor temperature and the
display’s TIMER light will turn on.
5.2 – Fan Mode
With this mode, the unit will turn on and begin using the fan to promote air circulation.
1. Press the power button on the control panel.
2. Press the mode button on the control panel until the display’s FAN light turns on.
3. Use the speed button to switch between fan speeds.
5.3 – Cool Mode
With this mode, the unit will turn on and regulate temperature as selected.
1. Press the power button on the control panel.
2. Press the mode button on the control panel until the display’s COOL light turns on.
3. Use the up and down buttons to set the desired temperature 62~86°F (16~30°C).
4. Use the speed button to switch between fan speeds.
In cool mode, the unit will not turn on if the chosen temperature is higher than the indoor temperature.
5.4 – Dehumidify Mode
With this mode, the unit will turn on and begin removing moisture from the air.
1. Connect the drainage hose to the upper drainage opening. Set a container near the unit to
collect the water (if needed). Then place the end of the drainage pipe in the container.
2 .Press the power button on the control panel.
3.Press the mode button on the control panel until the display’s DEHUM light turns on.
In dehumidify mode, the fan speed is automatically set to low and cannot be adjusted.