RP220 Dual Tube Mic Preamp Channel One GAIN Cha VOLUME GAIN NORM +48V -30dB NORM +48V INSTRUMENT INPUT +38 dB +65 - OO dB -30dB INSTRUMENT INPUT 0 PHANTOM INPUT PAD POWER +38 PHANTOM INPUT POWER PAD Dual Tube Microphone Preamp Channel Two VOLUME N PWR +65 Bellari is a division of ROLLS Corporation Salt Lake City, UT - OO dB 0 RP220 OWNERS MANUAL dB +65
OPERATION MICROPHONE INPUT EXAMPLE Connect a microphone to one of the XLR inputs located on the rear panel. If the microphone is a condenser type, press in the +48V phantom power switch. Connect the output to a mixer or recording device. Speak into the microphone and adjust the GAIN control for a signal level just below the point at which distortion occurs. Adjust the VOLUME control for the desired output level.
FRONT PANEL DESCRIPTION Note: Channel One descriptions are identical to Channel Two REAR PANEL DESCRIPTION Note: Channel One descriptions are identical to Channel Two PHANTOM POWER +48V Turns on the internal 48 volt power supply for using phantom powered microphones. It should be left off when not in use. INPUT Standard XLR type balanced inputs, pin 2 is hot, for Mic or line-level audio sources. (e.g., instrument, microphone or mixer).
TABLE OF CONTENTS Introduction Inspection Why Tubes? Front Panel Description Rear Panel Description Specifications Operation Microphone Input Example Line Input Example Instrument Input Example Warranty LIMITED WARRANTY 1 2 3 3 4 5 This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser’s receipt.
