User Manual Rollz Motion Rollator EN
Rollz International BV – Rollz Motion © Copyright 2012 Rollz ® International BV Information contained in this manual is current and based on the best information available to date. Our website at rollz.com is continually revised to provide you with notice of new information and updated manual. Please register your purchase at www.rollz.com to insure all benefits under the warranty and so we can notify you of any changes in the Rollz.
Contents Before you begin 4 Important information 4 Safety 4 Warning 5 Using your Rollz Motion 5 People who Should Not use the Rollz Motion 5 Check if your delivery is complete 5 multiple users 6 Use 6 What fits where? 7 Fold & unfold 8 Adjusting height 9 Operating the brakes 9 Walking with the Rollz Motion 10 Resting on the Rollz Motion 10 Crossing Curbs or Obstacles less than 6 inches 11 Bag 12 Maintenance 13 Adjusting the brakes 13 C
Before you begin Congratulations on the purchase of your Rollz Motion. Rollz International BV has written this manual so that you can use the Rollz Motion in the safest and most convenient way. We hope you will enjoy the use of your Rollz Motion. Important information • Read these directions carefully before you use the product and keep them in a safe place for future reference. Do not compromise your safety and that of others around you.
Warning • It is essential to make sure that the user has the physical ability to independently perform all the operations in this manual. If you cannot accomplish all functions, please make sure that you have continuing assistance. • Keep the Rollz Motion away from open flames and other heat sources, such as electrical heaters or gas heaters. • Do not use the Rollz Motion if any part has been broken or cracked, or if any part is missing.
WARNING! Keep the plastic packaging materials away from children. Children may play with it and suffocate. Discard the packaging materials without delay. Multiple users • The Rollz Motion can be lent or given to other users. • Every user must receive and review the entire user manual for safety and operation. • Before passing the Rollz Motion on to a new user, it should be cleaned, disinfected and checked by the dealer for damage to insure safe operation.
What fits where? 01 Figure 1: 01. Handles 02. Frame 03. Foam-filled rear wheels 04. Red seat lock button 05. Swivel front wheels 06. Front 02 04 03 05 06 Figure 1 Figure 2: 07. Hand brake lever 08. Height adjustment lever 07 09. Adjusting screws (to tighten brakes) 10. Front wheel lift supports 08 11. Parking brake locks 09 12. Height setting 13.
Folding & unfolding in (Fig. 3) Unfolding the Rollz Motion a. Gently pull the sides of the Rollz Motion apart until it stops. b. Push the seat down until it clicks, and locks into place. WARNING: The Rollz is not fully secured and ready for walking until you clearly hear the click and it is locked into place. To check the lock, pull up on the middle of the seat. It must be locked into place. Folding the Rollz Motion a.Turn the seat cushion around 90 degrees sideways as in Figure 3A. b.
Adjusting height Figure 4 All people are different and have their own requirements when it comes to using the product. The Rollz Motion can be easily adapted to suit individual needs. Correct adjustment can be crucial to get the most out of the Rollz Motion. a. To set the handlebar height, turn the adjustment levers counterclockwise (to the right) and slide the handles up or down for the height setting that suits you best. b.
The Rollz Motion is equipped with a parking brake to make sure it will not roll away when you let go, or if you decide to sit down for a rest. b. To lock the brakes, squeeze the hand brake Figure 6 lever and the parking locks firmly at the same time. Then release. c. To unlock the brakes, simply squeeze only the hand brake lever and release. WARNING: Squeezing the brakes too hard while walking can cause the Rollz to come to a rapid stop.
Crossing Curbs or Obstacles less than 6 inches Rollz products are made to make life easier for the user. Rollz Motion has designed a lift support lever located inside the rear wheels on both the left and right sides. a. Place the front wheels of the Rollz Motion against the curb. b. Using your right or left foot, push the lift support lever down. At the same time pull the Rollz Motion up and back by the handgrips. The front wheels of the Rollz Motion will now come off the ground.
Bag The use of the bag saves you from heavy lifting. You can easily attach or remove the bag. Attaching the bag. a. Place the bag with the narrow mounting loops toward the rear of the Rollz Motion (Fig.9). b. Using the Velcro, attach the two wide mounting loops to the frame (Fig. 10). c. Connect the narrow mounting loops to the hooks on the frame (Fig. 10). Using the bag. a. Access the bag from the back of the Rollz Motion. b. The empty bag can be left attached while retracting the frame. Removing the bag.
Maintenance Regular maintenance will increase the life and safety of your Rollz Motion. Rollz International recommends maintenance takes place every two months. Adjusting the brakes While squeezing the hand brakes, the Rollz Motion should be unable to move. After releasing the hand brakes, the Rollz Motion should be able to move freely. Test the brake function before each use. If stopping performance is not adequate, there are two ways to adjust the brakes.
Cleaning/ disinfection Frequent cleaning of the Rollz Motion is recommended to keep it in optimal condition. Before passing the Rollz Motion on to a new user, it has to be disinfected. Clean the frame and handgrips using lukewarm water and a cloth. For more resistant stains you can use a mild detergent. Avoid excessive water contact with moving parts, such as axles and hinge points. Thoroughly dry your Rollz Motion after cleaning.
Replacing parts Some parts, like handles and the seat cushion, are subject to wear and tear and must be replaced in a timely manner. Please contact your supplier for the replacement of parts. WARNING: Only use original or Rollz International BV approved parts. Accessories Get more out of your Rollz Motion by using accessories. Only use original or Rollz International BV approved accessories. New accessories come onto the market from time to time. For an update, check our web site on www.rollz.
Maximum sideward slope The Rollz Transport Chair is intended only to be used on flat level hard surfaces. While it is possible to push the chair up a slight incline, NEVER use across any slope. Max ≈ 15˚ What fits where 21. Guide rails against the seat 22. Red handle 23. Transport chair bag 24. Footrest holders 25. Backrest 26. Armrests 27. Guide rails on the frame 28. Footrests 29. Transport chair function / package 30.
Attaching the Rollz Transport Chair pack Figure 18 Figure 19 Unlock a. Take the Rollz transport chair pack and hold the transport chair bag towards you Figure 20 b. Use your other hand to pull the red handle up and place the Rollz transport chair pack in the guide rails against the seat which are located next to the silver weight label. Figure 21 Lock c. Push the red handle down without any force. You can now simply walk behind the Rollz Motion.
Unfolding the Transport Chair pack Attach the transport chair bag to the Rollz Motion before you leave. If you want to take a break, just unfold the transport chair pack and click it into the frame. ‘click’ Figure 22 Figure 23 a. Take the handle of the transport chair pack and pull up the backrest to the maximum setting and towards the front until halfway up the frame b. Then pull the backrest back until the locking bolts click into the guide rails on the frame. Figure 24 c.
Figure 25 Figure 26 d. The footrests are located in the transport chair bag. Place the footrests at the front of the Rollz Motion into the footrest holders by pushing them down from the top of the footrest holders. e. If the armrests are not attached to the frame. Place them around the frame on the spot where your arms rest. Secure them by using the Velcro on the bottom of the armrests.
Backrest Rollz Transport Chair In order to ensure maximum comfort, it is important to adjust the straps in the back of the transport chair pack. To do so please follow the next three steps: a. Remove the footrests from the transport chair bag and make sure the back of Rollz transport chair pack is extracted (see: page 46). b. Loosen the Velcro at the back of the transport chair pack by pulling the bag upwards. c. Adjust the straps by loosening the Velcro.
Technical specifications • Maximum weight of the user: 275lbs or 125 kg • Minimum and maximum physical height of the user: 63 in to 74.8 in or 160 - 190 cm • Net weight of the product o Rollz Motion: 23.7 lbs or 10,6 kg o Rollz transport chair pack: 8.16 lbs or 3,7 kg • Dimensions: o Extended -> HxLxW: 33.9-40.2 x 25.8 x 24.8 in or 86-98 x 65.5 x 63 cm o Retracted -> HxLxW: 33.9-40.2 x 11.4 x 24.8 in or 86-102 x 29 x 63 cm o Handle Height Range: 33.9-38.6 in or 86-98 cm o Rollator seat -> HxWxL: 21.7 x 17.
Warranty Rollz International BV, with its registered office in Amsterdam (hereafter called „Rollz“), in its capacity of manufacturer, provides a warranty for its product called „Rollz Motion“ (hereafter called „the product“), on the following conditions: 1. The warranty period is 24 months from the purchase date. There will be no extension of the warranty period, not even in the case of repairs. 2. The warranty gives the buyer the right of repairs; explicitly not the exchange or return of a product. 3.
