Use and Care Manual

Technical Data: PRO-880

Updated: 2/8/16

Roman Decorating Products – Calumet City, Illinois

For Technical Help: Call 1-800-488-6117 or Email: technicalhelp@romandec.com

www.romandecoratingproducts.com

PRO-880

Ultra

Clear Adhesive

Clear, Strippable, Non-Staining Wallcovering Adhesive

Product Number(s): 12405, 12401

Base: Starch, Water-based

Product Information

General Properties: Premium clear, strippable wallcovering adhesive. PRO-880

is excellent for the retail customer as well as the most discriminating contractor.

Undiluted PRO-880 will hang Type II and Type III wallcoverings, and may be

diluted for use with lightweight and pre-pasted wallcoverings. PRO-880 applies

easily with a roller or pasting machine.

 Maximum wet-tack

 Machinable

 Extended open time

 Ease of clean up

 LEED compliant

Recommended Uses: For all weights of wallcoverings. Strippable when

used with fabric-backed vinyl over bare drywall with a cure time of six weeks.

Compatible Coatings: All ROMAN

primers

Substrates: Apply over new, bare drywall or over a ROMAN

primer

Mildew-Resistant: All Roman products contain biocides for in-can

preservation

Specification Data

Percent Solids: Approximately 32%

Coverage: Up to approx. 330 square feet per gallon

Viscosity: Approximately 40,000 - 45,000 cps

VOC (actual/regulatory): 0% / 0 g/L as calculated per EPA Method 24

Storage: Avoid freezing; keep in cool, dry place

Drying Time: Drying time will vary depending on the temperature, ventilation

and humidity of the room.

 Strippable with most fabric-back

wallcoverings

 Spreads and flows easily

PAGE 1
Technical Data: PRO-880 Updated: 2/8/16 PRO-880 Ultra® Clear Adhesive Clear, Strippable, Non-Staining Wallcovering Adhesive Product Number(s): 12405, 12401 Base: Starch, Water-based Product Information General Properties: Premium clear, strippable wallcovering adhesive. PRO-880 is excellent for the retail customer as well as the most discriminating contractor. Undiluted PRO-880 will hang Type II and Type III wallcoverings, and may be diluted for use with lightweight and pre-pasted wallcoverings.
PAGE 2
Technical Data: PRO-880 Application Instructions Updated: 2/8/16 Surface Preparation: Surface must be free from grease and other residues, dry, smooth and structurally sound. Check surfaces for paint bonding, loose wallcoverings, damaged wall- board or plaster. Repair all unsound surfaces. Priming of bare drywall is not required with fabric-backed wallcoverings. Before proceeding with any unusual conditions, consult your adhesive or wallcovering supplier.