Datasheet

• By touching the “+“ sensor (4) you can

increase the operating time in minute

intervals up to 99 minutes.

• By touching the

“

-“ sensor (5) you can re-

duce the operating time in minute inter-

vals.

• By continuously pressing the “+“ sensor

(3) or “-“ sensor (5) you can increase or

reduce the operating time in 5-minute

intervals.

• Once the set time has elapsed there is an

audible signal and the control automati-

cally switches over to standby mode.

NOTE: Changing the power or temperature level will not affect the set operating time.

Switching-off

• For switching-off touch the main switch

sensor (1).

• The display “temp“ (7b) shows “-L-“ or

“-H-“, depending on the residual heat on

the cooking zone. Also an audible signal

sounds. Now the control is in standby

mode.

NOTE: If the waste heat of the pot creates a temperature on the cooking zone of more than 50 °C

the display “temp” (7b) shows “-H-“ for HOT. As soon as the temperature has sunk below 50 °C,

the display “temp” (7b) shows “-L-“ for LOW.

When the unit is disconnected from the mains the display “temp” (7b) expires.

NOTE: It is normal for the fan to continue running in the standby mode after a long operation time.

OUR ADVICE: Electrical appliances featuring a standby mode consume some power also in

non-operating state. Save energy by disconnecting your appliance from the mains during non-

use periods by pulling the mains plug.

Before cleaning always disconnect the unit from the mains!

Let the appliance cool down before cleaning!

• Remove any coarse residues from the glass ceramic plate by means of a special glass scraper,

which is available in the specialised trade and in household equipment shops.

• Following that clean the cold glass surface with a damp cloth and some dishwater and wipe it

dry with a clean cloth or kitchen tissue. On the market there are suitable cleaning agents for

glass ceramic cooktops available with which the whole glass surface is treated by means of a

kitchen tissue until there is no soiling visible anymore.

• Never immerse the appliance into water and do not use steam jet appliances.

Cleaning and maintenance