Owner's manual

REV. OCT, 2013ronbow.comINSTALLATION GUIDE

INSTALLATION SHEET

ACCESSORIESMODEL: 600823

601224

602523

LED MIRROR

MATERIALS NEEDED:

PHILIP SCREWDRIVER

LEVELING TOOL

DRILL

MATERIAL PROVIDED:

(2)WOOD SCREWS

(2)ANCHORS

Circuit Breaker

ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENSED ELECTRICIAN.

WARNING: To reduce the risk of electrical shock, shut o power before wiring the cabinet.

CAUTION: Requires 120V 20AMP circuit.

CAUTION: The LED mirror must be wired to a 20AMP GFI (ground fault interrupter) circuit breaker when used in bathrooms

and all other locations required by the national electric code.

Wall Terminal

Black Black

White White

Ground

20AMP CFI

Figure 1.STEP 1: Determine the ideal location of your new

LED mirror. Make sure mirror has enough clearance

from faucet and ceiling.

See Figure 1.

Minimum to Faucet

Minimum to Ceiling

1”

PAGE 1
LED MIRROR MODEL: 600823 601224 602523 ACCESSORIES INSTALLATION SHEET MATERIALS NEEDED: MATERIAL PROVIDED: PHILIP SCREWDRIVER LEVELING TOOL DRILL (2)WOOD SCREWS (2)ANCHORS All wiring should be done by a qualified licensed electrician. Warning: To reduce the risk of electrical shock, shut off power before wiring the cabinet. Caution: Requires 120V 20AMP circuit.
PAGE 2
LED MIRROR MODEL: 600823 601224 602523 STEP2: Drill pilot holes into the wall. ACCESSORIES INSTALLATION SHEET Figure 2. See Figure 2. Pilot Holes STEP 3: Secure the anchors in the wall, and then fasten the screws provided into the anchor. Note: Allow about 1/8” clearance from screw head to wall. STEP 4: If the mirror is not flush to the wall it is recommended to cut the plug and hard wire to the house. In this case we recommend a licensed electrician. Figure 3. Wall Outlet See Figure 3.