User's Manual

RONDISH STRIP DOOR MONITOR
DMS-02
6. DRAWINGS – INSTALLATION AND SETTING UP
6.1 INSTALLATION GUIDE (PAGE 1 OF 3)
PCB
Optional electric door
lock connection
+
Magnetic contacts for optional
caregiver magnetic key alarm
reset
12Vdc 500mA regulated ac mains adaptor, or PSU
(regional ac mains voltage to apply)
Alarm contact output
(0Vdc J15 flash/steady)
Cable entry
port
Removable (slide-off)
cover
Optional free socket and cable
for ac adaptor connection
(fitted as standard)
DRAWING No.
001/1V2
PVC Sheathed
two core flexible cable
(black colour)
Translucent plastic housing
(white colour)
TITLE
MODEL No.
Strip Door Monitor unit
DMS-02
Standard adaptor
plug (12Vdc)
Optional magnetic door
contacts connection
Use standard Rondish ac adaptor (ACCE-04,) or power supply of sufficient capacity
if door locks are to be connected.
For detailed wiring connections, refer to drawing 001/3
NOTE:
Holes for
cable tie
Cable tie
(loop cable through for strength)
Red alarm and set-up LED indicators
(inside white translucent cover)
Door zone range setting, door lock timing, door
identity and area coding program
(16 way rotary switch)
Sounder level adjust
SW1
Mode button for
programming
+12V
CONTACT
0V
0V
N/C
TX
RESET
ALARM
(COM)
LOCK
+12V
CONTACT
0V
+12V
J18
J11
J15
Optional wired
data connection
(J15 Tx, or wired)
Optional wired
reset connection
(keypad, card reader etc)
Common +12Vdc power
Common power 0V
Not used
Common 0V
Common +12Vdc power
Optional magnetic door
contacts connection
Common power 0V
Optional wired
reset connection
(keypad, card reader etc)
RESET