Specifications

FCC/CE Statement
FCC Interference Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Notice:
Any changes or modifications not expressly approved by the
party responsible for compliance could void your authority
to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
The antenna(s) used for this transmitter must not be
co-located of operating in conjunction with any other
antenna or transmitter.
This device complies with FCC radiation exposure
limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the Fcc radio
frequency exposure limits, human proximity to the
antenna shall not be less than 20cm (8inches) during
normal operation.
RF exposure statements
This equipment complies with FCC radiation
exposure requirement set forth for an
uncontrolled environment. End users must follow
the specific operating instructions for satisfying
RF exposure compliance.
Operate Frequency Bands : 2.4G
Max. output power: 10mW
EU declaration of conformity
Rondish Company Limited hereby declares that the
device is in compliance with the essential
requirements and other relevant provisions of
directives 2014/53/EU, 2014/30/EU and
2014/35/EU.