User's Manual

WCP-11 User Manual

Version: 0.2

Date: 2019-02-11

Page: 1 of 3

RONDISH PROPERTY and CONFIDENTIA

1. Power up

a. Apply CR2477 x2

b. Red led will stay ON with a beep sound

c. WCP-11 will transmit battery return signal

d. After transmission finished, led will go OFF

2. Programming WCP-11

A. Entering programming mode:

1. Apply magnet on WCP-11

2. LED will flash

3. Press and hold the “CALL” button

4. When LED stays ON, release both the button and magnet

5. Now it is in programming mode

B. Programming WCP-11 parameters

1. Enter the password: 36

a Press call key 3 times and apply magnet to confirm the password 3

b Press call key 6 times and apply magnet to confirm the password 6

c If password is wrong, it will exit the programming mode

d If password is correct, it will continue the programming mode

2. Enter: D1D2-D3D4D5D6-T D1D2 = group number

D3D4D5D6 = ID number

T = tracking function

3. After entering the value, the red led will flash and then exist the programming mode

Remarks:

D1 D2 = 2 digits for group number

D3D4D5D6D7 = 4 digits for ID number

T = 1 digit for tracking function ON or OFF (0 = OFF, 1 = ON)

C. Auto-exiting programming mode: 25 – 35 sec

a In programming mode, if WCO-11 is left in-active for about 30 seconds

b The red led will flash 3 times

c WCP-11 exit programming mode automatically

PAGE 1
WCP-11 User Manual Version: 0.2 Date: 2019-02-11 Page: 1 of 3 1. Power up a. Apply CR2477 x2 b. Red led will stay ON with a beep sound c. WCP-11 will transmit battery return signal d. After transmission finished, led will go OFF 2. Programming WCP-11 A. Entering programming mode: 1. Apply magnet on WCP-11 2. LED will flash 3. Press and hold the “CALL” button 4. When LED stays ON, release both the button and magnet 5. Now it is in programming mode B. Programming WCP-11 parameters 1.
PAGE 2
WCP-11 User Manual Version: 0.2 Date: 2019-02-11 Page: 2 of 3 4. WCP-11 learning with ILB03 A. Learning the “CALL” function a. Enter programming mode b. Enter password “4” and “1” c. ILB-03 will learn for “CALL” button d. Test ILB-03 with the alarm call B. Learning the “RESET” function a. Enter programming mode b. Enter password “4” and “2” c. ILB-03 will learn for “RESET” button d. Test ILB-03 with the reset 5.
PAGE 3
WCP-11 User Manual Version: 0.2 Date: 2019-02-11 Page: 3 of 3 FCC/CE Statement FCC Interference Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.