User's Manual Part 2



#

There are 5 steps to program each Zone Protektor.
1. Set Network ID
2. Set High Frequency Wireless Channel (must match Master Care Station)
3. Set Target Address
4. Set Zone Protektor Address
5. Set Site/Area Code
Enter programming mode to set the Network ID, Channel, and Target Address.
Press and hold the T-SW button until the Tx/Rx LED on the front panel flashes and
remains on.
30 2(
The Network ID setting must be the same for all Zone Protectors and Master Care
Station communicating on the same High Frequency network and prevents receiving
unwanted calls from a nearby system.
Adjust the “Address” rotary switch to the required Network ID:
0-3 (factory default =“0”)
Then press the T-SW button once and the Tx/Rx LED will flash once to accept the
input.
30/+.'!"-9&.""&
The High Frequency wireless channel must be the same as that chosen on the
Master Care Station. This can be adjusted using the rotary switch at “Address” to
set a new digit:
0-4 for the 868MHz frequency band (CE)
0-9 for the 916MHz frequency band (US).
Press the T-SW button again to confirm the setting.