User's Manual Part 2
>
3,0+##
The Target Address for the ZP-01 to communicate with the Master Care Station,
should be set to “48” (i.e. = <MO> as set at Master Care Station), or the address of
another Zone Protektor.
(1) Adjust the rotary switch to “4” and press the T-SW button,
(2) Adjust the rotary to “8” and press T-SW again.
(3) The Tx/Rx LED will then come back on and stay on “steady” briefly to indicate
“programming finished”.
(4) The ZP-01 then automatically exits programming mode, reboots itself and returns
to normal operating mode.
330* " 2 ##
This parameter tells the Master Care station where to send signals. This ZP
address” (“00-47”) must be unique within the system so it can be individually called by
the Master Care Station and various Call Points.
The ZP-01 unique address is set by adjusting the rotary and DIP switches at
“Address”. This setting can be selected without entering “Program Mode”.
The matrix chart below can be referred to when adjusting the rotary and DIP switches
to set the required ZP Address.