User's Manual Part 2
For example, setting ZP Address to “18”:
(1) setting of “2” on the rotary switch
(2) setting of POS 1: ON and POS 2: OFF on DIP switch
When this is changed the ZP-01 should be turned off and then back on.
340"+7 #
This feature will prevent a Zone Protektor from processing calls from equipment in
different areas, and a Slave Monitor (see page 13) can then be used to display calls
from only within the area.
This can be set at the Zone Protektor without the need to re-enter “programming
mode” by setting the separate rotary switch found above at “Area Code” (0-9).
The Master Care Station should be set to Area “0” so it receives calls signals from
any Protektor II equipment within wireless range, regardless of site area. If no Slave
Monitors are planned for the network, set every Zone Protektor area to “0”.
When this is changed the ZP-01 should be turned off and then back on.