Phau Ntawv Qhia

3/4"AIR IMPACT WRENCH 1800 N .M
6
Air compressor
size & power
2HP 2-1/2 HP 3+ HP
5-6 Gallons
Light duty and
intermittent use
Light duty and
intermittent use
Medium duty and
intermittent use
8-11 Gallons
Light duty and
intermittent
Use
Medium duty and
intermittent use
Heavy duty and
continuous use
15+ Gallons
Medium duty
and intermittent
use
Heavy duty and
continuous use
Heavy duty and
continuous use
Heavy duty and
continuous use
OPERATING INSTRUCTION
AIR SUPPLY
1- Always use clean, dry, regulated, compressed air at 4 to 7bar (60 to
100PSI).
2- Do not exceed the maximum and minimum pressure. Operating the tool
at the wrong pressure (too low or too high) will cause excessive noise or
rapid wear.
3- It is recommended that a lter-regulator-lubricator be used and be
located as close to the tool as possible.
4- If a lter-regulator-lubricator is not installed, place up to 6 drops of
pneumatic tool oil into the air inlet plug before each use.
5- If a lter-regulator-lubricator is installed, keep the air lter clean. A dirty
lter will reduce the air pressure to the tool, which will cause a reduction in
power, efciency, and general performance.
6- Clean air inlet lter weekly.
7- Line pressure should be increased to compensate for unusually long air
hoses (over 8 meters). The hose diameter should be 3/8” I.D.
8- Do not use oxygen or any other combustible or bottled gas to power this
tool.
9- Do not use this tool in the presence of any ammable liquids or gases.