Assembly Instruction

800.301.9720 | roomandboard.com
4/1/11
assembly instructions: pogo bed
List of parts
1 – headboard
1 – footboard
2 – bed rails
1 – slat roll
Hardware
4 – wood dowels
8 – connector bolts
8 – metal collars
28 – wood screws for slat roll
Tools needed
ball end Allen wrench (provided)
DO NOT USE POWER TOOLS
Directions
1. Insert a wood dowel into the middle hole of each trio of holes on both the headboard
and footboard. Screw a connector bolt into each of the barrel nuts, leaving four or five
threads exposed.
2. Align connector bolts with the holes on the end of a bedrail, slipping bolts through
pre-drilled holes in the bedrail. Repeat on other side. Make sure each bedrail is tight up
against the post.
3. Through the large hole in the side of the bedrail, slip one metal collar over each connec-
tor bolt. Use the ball-end allen wrench to start tightening each bolt, then switch to the
short end to finish tightening completely.
4. Unroll and lay the slatroll inside the bedrails equidistant from each end, with the webbing
facing up. With the 28 wood screws provided, attach the slats.
Cleaning
Mix a mild solution of gentle dishwashing liquid and water, apply to surface using a soft,
clean cloth, then dry all surfaces with a soft, dry cloth. NO ABRASIVES, SCOURING
PADS, STEEL WOOL, OR COARSE RAGS should be used to clean this fine furniture.
Replacement parts, including additional guardrails, may be obtained from any Room &
Board store.
MADE IN New York
MADE IN
New York
footboard
tip
Wood naturally expands and contracts causing bed connections to loosen over time. This
process is a natural characteristic of wood. Tighten hardware occasionally to restore the bed
to original stability.
headboard
B A R R E L
N U T
Steps 1-3: bedrail attachment