Installation Guide
RoomMates Peel & Stick Decor
HANGING INSTRUCTIONS
Please read these instructions carefully before hanging
as a wallcovering.
INSPECTION SPECIFIC TO WALL APPLICATIONS
Make sure all rolls are from the same run number for exact color matching prior to cutting and hanging.
TOOLS REQUIRED
Tape Measure · Level · Steel Ruler or Straight Edge · Razor Knife · Pencil · Plastic Smoother
SURFACE PREPARATION
For best results, clean, dry and smooth all surfaces. Product will not adhere to unclean or textured surfaces. Allow
newly painted surfaces to fully cure for a minimum of 4 weeks before applying this
Peel & Stick Décor.
HANGING (IT HELPS TO HAVE TWO PEOPLE)
1. Pre-cut strips to t wall height, allow an extra inch or two for trimming both the top and bottom. Make sure to
align any design from strip to strip. Cut and trim product with a sharp razor knife changing the blade often to help
maintain a smooth clean cut. Number the back of each strip as you go to keep your design in the correct order (only if
pattern requires it).
2. Beginning on the left side of your wall, measure out from the corner the width of the paper (20&1/2”) and mark
the wall lightly with a pencil. Put your level on this mark and draw a straight, level, vertical line. This is the guide for
your rst strip, it is very important for it to be level.
3. Peel about 12” of the backing away from the paper. Apply the paper to the top of the wall, allowing a bit of excess
to overlap the ceiling which will be trimmed o later. Align the right side of the strip to your mark and lightly press the
edge to the wall along the mark. You can reposition if needed to ensure a vertical seam. Working from top to bottom,
pull the backing away as you evenly press the paper to the wall. Do not force, let gravity assist you. Be careful not to
pull or stretch the material or the pattern will not align. For best results , have one person guide the paper at the top
and along the seam, while another holds the opposite edge away from the wall until the seams are lined up.
4. Using a plastic smoother, work your way down the strip in a back and forth motion, smoothing the material to the
wall and pushing out any air bubbles.
5. Trim o excess material at ceiling and baseboard with a straight edge and sharp razor knife.
6. Repeat procedure aligning your next strip to the right edge of your previous strip.
REPOSITIONING OR REMOVAL
Start at the top corners gently pulling rmly, evenly and slowly downward, working parallel to the surface. Be careful
not to over stretch the material. Do not allow the adhesive surfaces to make contact with each other as they are very
dicult to separate without damaging.
CLEANING
RoomMates Peel & Stick Decor is washable and can
be cleaned using a mild detergent and a damp sponge or cloth.
FOR bEST RESULTS
Apply onto smooth and clean surfaces. Do NOT apply onto freshly painted or papered walls (let paint or wallpaper dry
for at least 4 weeks). Do NOT apply to lacquered furniture. The fading of furniture exposed to sunlight is not related to
the use of our product. May not work on heavily textured surfaces. Test in an inconspicuous area before applying to
wallpaper or other delicate surfaces. Keep decorations away from cribs and out of reach of young children to prevent
choking hazard.