c Installer: Leave lnstallotion Save Installation Instructions Instructions for local Undercounter Dishwasher
Before vou start... L Proper installation is your responslblltty Make sure you have everything necessary for correct installation It is the responsibility of the customer to contact a qualified installer to assure that the plumbing and electrical lnSk3llO~iOnS are adequate and meet national and local codes and ordlnonces. Proper electrlcol, drain and water lines must be ova~loble or must be Installed. as speclfled. wlthin shaded area.
4. Connect the green, grounding wire of the power supplY cable to the grounding connection screw located inside the terminal box. [See Figure 3 ] 5. Replace terminal box cover. Alternate groundlng method If the recommended grounding method is impossible-connect a separate. green. grounding wire [No 16 minimum] from grounding connection screw located inside the termlnol box to a grounded. copper, cold water pipe’ (See Figures.) Dishwashers equipped with a power supply cord have a 3-prong.
Drain requirements Insertin Dishwas %er in Opening Some models ore not equipped with a drain hose. A drain hose that meets AHAM DW-I test standards must be securely clamped to the pump’s drain outlet. Drain hoses are available through your Roper dealer. Drain hose, when supplled, meets AHAM DW-1 test standards. 1 Shut off water line valve Check n that electric supply is off Drain line connectIon to house plumbing must be mlnlmum 20” Cut 1%” hole in cabinet wall for drain hose.
Open door approximately check for equal spacing inner door ond tub sides. loosen screws that fasten countertop and shift tub. screws. 3” and b&Men If necessary. dishwasher to Tighten Check door for proper-&ration. Door should close easily without slamming and open with its own weight. If necessary. close door and adjust dooc spring with pliers 14. Take o few minutes to read the Use and Care Guide to fully understand your new dishwasher.
Installing Customized Wood Door Panels To Change Door And Access Panel Color Dishwasher door panel and access panel can be customized to match wood cabinets. l^t /---- -----------I Hondle metal edges of panels carefully. Cut metal edges may cause personal InJury or domage fo other materials.
IF THE DISHW’HER IS NOT OPERATING PROPERLY.. . Check these points: l Is the door closed tightly and latched securely? l Has the cycle been set correctly to start the dishwasher? l Is the water turned on? l Has a house fuse blown? l Has electrical power been interrupted? Note: If the motor has stopped because of overload. it will automatically reset itself within a few minutes. If after checking these points the dishwasher still does not run or complete a cycle, call for service. ROPER ‘OrI No.