Product specifications

GALAXYNASLX CONFIGURATION AND SYSTEM INTEGRATION GUIDE
58 Section 3 Menu Functions
Simple means, that the GalaxyNASLX is the only system attached to this UPS and that there
is no action necessary to do remote shutdown for other systems in the network.
Master means, that the GalaxyNASLX is connected to the UPS and sends a signal through
the network to shutdown other systems in the network.
Slave means, that the GalaxyNASLX is reacting on a "power down-signal" from an UPS
master.
" Note: During a power failure you cannot log into the NAS. Users who are
connected to the GalaxyNASLX during the UPS-time remain full access to all files on
the NAS server.
3.6.0 ‘Setup’ ‘disk manager’ Functions
3.6.1 Function “Synchronize mode” Figure 3.20
If more than two GalaxyNASLX are in use, you have the option to synchronize shares
between them. Configure the shares, provide one GalaxyNASLX server as the “source”, then
pick the desired ‘sync’d’ shares by adding them to the right window. Then type the IP address
of the other GalaxyNASLX server into the corresponding field and pick a synchronization
interval. Please consider that choosing small intervals can increase network traffic
considerably.
The destination machine needs to be configured as “destination” using the “Synch. Mode”
drop-down. Again, you need to provide the IP access of the source NAS server.
" Note: The synchronization has to be started by clicking “apply” with both the source and
the destination NAS server totally configured.
To configure a source mode:
Select "source" from “Synch. mode" to choose the role of the source for this node.
Give the IP address of the destination node in the "Destination IP" field.
If your destination NAS is in version 1.71 or above you can choose "automatic" synchronize
type, otherwise please choose "manual".
Click apply
To configure the destination GalaxyNASLX :
If your source NAS is in version 1.71 or above and you have chosen "automatic" synchronize
type on source NAS, then you do not need to configure destination NAS!
Select "Synch. mode" to destination
Type in the address of source node.
If your source NAS is in version lower than 1.71 please choose "manual" destination
synchronize type.
Click apply