Product manual

Galaxy G3G12 / G3G16 - Installation and Hardware Reference Manual
190 Section 5 Management with CLU
2. Highlight Software Management and press Enter.
3. Highlight Webserver and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic and Manual.
5. Highlight the following and press the backspace key to erase the current value, then type the new
value:
• HTTP Port – 80 is the default
• Session Time Out – 24 minutes is the default. 1440 minutes = 24 hours
6. Highlight SSL and press the spacebar to toggle between Enabled and Disabled.
7. Highlight HTTPS Port and press the backspace key to erase the current value, then type the new
value. 443 is the default.
8. Press Ctrl-A to save your settings.
To start, stop or restart the Webserver service, highlight Start, Stop, or Restart and press Enter.
Making Telnet Settings
By default, Telnet service is set to Automatic and its normal status is Started. To make Telnet service
settings:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight Software Management and press Enter.
3. Highlight Telnet and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic and Manual.
5. Highlight the following and press the backspace key to erase the current value, then type the new
value:
• Port number – 2300 is the default
• Session Time Out – 24 minutes is the default. 1440 minutes = 24 hours
• Maximum number of connections – 4 is the default
6. Press Ctrl-A to save your settings.
To start, stop or restart the Telnet service, highlight Start, Stop, or Restart and press Enter.
Making SNMP Settings
By default, SNMP (Simple Network Management Protocol) service is set to Automatic and its normal status
is Started.
To make SNMP service settings:
From the Main Menu, highlight Additional Info and Management and press Enter.
Highlight Software Management and press Enter.
1. Highlight SNMP and press Enter.
2. Highlight Startup Type and press the spacebar to toggle between Automatic and Manual.
3. Highlight the following and press the backspace key to erase the current value, then type the new value:
• Port Number – 161 is the default
• System Name – (optional) Type a system name in this field
• System Location – Type a country name in this field
• System Contact – Type the email address of your system administrator in this field
• Read Community – Type a community name in this field
• Write Community – private (no change possible)
4. Press Ctrl-A to save your settings.
To start, stop or restart the SNMP service, highlight Start, Stop, or Restart and press Enter.