Product manual

Galaxy G3G12 / G3G16 - Installation and Hardware Reference Manual
283 Section 8 Troubleshooting
State
LEDs
Dark Amber Green
Flashing
Green
Connectivity 10BaseT 1000BaseT 100BaseT
Activity No activity Activity
Note that Galaxy3G Management Port can accept IP address assignments from a DHCP server. Use
Galaxy3G’s Command Line Utility (CLU) to enable this feature. If you have not activated DHCP support but
there is a DHCP server on your network, there is a chance that it will inadvertently assign the Galaxy3G’s
Management Port IP address to another node. You might see a warning to this effect on your PC's monitor.
If this happens, the Galaxy Array Manager may not be able to connect. See your network administrator to
work out a suitable arrangement.
Fibre Channel Connections
When there is a connection failure, use Galaxy Array Manager to verify that Galaxy3G sees the initiator(s).
See “Viewing Fibre Channel Initiators” .
If Galaxy3G sees some initiators but not the one you want, the problem is most likely elsewhere in the loop
or fabric. If Galaxy3G does not see any initiators:
• Check all of the Fibre Channel connections
• Verify that all nodes are properly connected and powered
• Verify that the fabric router or switch is properly connected powered
The Fibre Channel ports, transceivers, and controller on Galaxy3G function the same as comparable
components on other nodes.
For more information, see “Managing Fibre Channel Connections” ..