Product manual

Galaxy G3G12 / G3G16 Installation and Hardware Reference Manual
36 Section 2 Installation / Connectivity
• Install four rail adjustment screws (included) through the flange into the rail.
• Attach a two-hole flange to the rail, with the flange toward the back (connector end) of
the enclosure.
• Install four rail adjustment screws (included) through the flange into the rail.
• Repeat steps 4 through 6 to attach the other rail and flanges to the enclosure.
• Place the enclosure with mounting rails into your rack system.
• Attach the four-hole flanges to the inside of the rack’s front post, using the attaching
screws from your rack system.
• Attach the two-hole flanges to the inside of the rack’s rear post, using the attaching
screws from your rack system.
• Square the rails in the rack.
• Tighten the adjustment screws and the attaching screws.
2.3 Installing Disk Drives
Your salesperson has passed on your RAID level requirements to our integration department and we
have pre-configured your RAID level with a RAID Partition on them. The drives can be installed in
any of the G3G drive slots since the G3G is intelligent enough to properly configure the RAID, once
it is powered up, no matter where the drives are located in the chassis.
However, if you do want to re-configure you RAID, the G3G is capable of all the RAID levels
displayed in the table below.
Inside of post
Rack front post
Rail attaching screw
(not included)
Rail adjustment screw
Rail
Rail attaching screw
(not included)
Inside of post
Rack back post
Plate
Front flange
Rail adjustment screw
Rear flange
Fig 2.2b Rackmount hardware diagram