Product manual

Galaxy G3G12 / G3G16 Installation and Hardware Reference Manual
41 Section 2 Installation / Connectivity
2.4 Configuring Management and Data Cable Connections
For Serial Attached SCSI [SAS] host setup, go to 2.42 Serial Attached SCSI host setup
Fibre Channel Host Setup fig 2.4.1a
G3G models can have one or two RAID controllers. Each controller has an Ethernet (RJ45)
Management Port connector that enables you to monitor the G3G over your network using the
Galaxy Array Manager Software. G3G supports HTTP(S) and Telnet protocols.
The G3G RAID controller has two 4-Gb Fibre Channel (FC) connections for the data ports. See
figure 2.4.1a.
You can configure your G3G for:
Storage Area Network (SAN)
Direct Attached Storage (DAS)
JBOD Expansion using a SAS data connection
Important
For ease of use the G3G12 chassis is shown for the cable and
connectivity configurations. The G3G16 connections are
identical and follow the same procedure.
Fibre Channel data port 1
Management port
Fibre Channel data port 2
SAS expansion
port (to JBOD)
Fig 2.4.1a G3G Fibre controller description
of cable connectivity