Operating instructions

PAGE 6 www.rosco.com GENERAL INSTRUCTIONS
simply an indication to the operator that the fluid level should be checked and will not affect
the performance. Because the bottles will “self-level” a Low Fluid Sensor is only required in
one bottle.
Pump Cut Off: The Delta 6000 is also equipped with a thermal cut-off that is attached to the
pump. If the machine is running when the fluid bottle is empty, the pump could start to
overheat at which time the thermal sensor will cut off power to the pump. Avoid running the
machine without fog fluid to prevent damage to the pump.
CAUTION: The machine only works with uncontaminated Rosco fog fluids. Other
manufacturers’ fluids may cause spitting and serious clogging problems and could result
in the production of an unhealthful aerosol. The use of other fluids voids the warranty of
the Rosco Delta 6000 fog machine.
5. 0-10 VOLT INPUT
In addition to operating directly from the remote controls and a DMX console, the Rosco
Delta 6000 is also equipped to operate from a 0-10 volt input. The input is located on the rear
of the machine near the DMX connectors. The 0-10 volt input is wired through an RJ-11
connector. Pin 1 is positive and pin 4 is negative. The 0-10 volt input will ONLY operate the
Delta with a remote attached and power turned on at the remote.
6. AIR INPUT
The Delta 6000 is equipped with Air Input located at the rear of the machine. This is to allow
the use of compressed air to clean the heat exchanger. In addition, compressed air can be used
for effects.