Operating instructions

PAGE 8 www.rosco.com DIGITAL/DMX INSTRUCTIONS
button once. The Language Menu will display. Push an ARROW button to scroll through the
language choices. When the desired language is displayed, push the ENTER button.
9. MANUAL MODE
To produce fog manually: With the Operation Menu displayed, push the RUN button or the
momentary (MOM) button located on the remote control. Push the RUN button again to stop
producing fog. (The momentary button will stop producing fog as soon as it is released.) The
volume of fog can be varied by turning the JOG WHEEL until the desired level is reached.
The output level is listed in 5% increments on the LCD display.
10. TIMER MODE
The DIGITAL/DMX REMOTE CONTROL is equipped with timers. To enable the timers:
With the Operation Menu displaying, push the ENTER button until the LCD reads “SET
TIMERS”. Push an ARROW button until “YES” is blinking. Push the ENTER key. The
LCD will next display the ON TIME settings. This refers to the amount of time that the
machine will make fog. The “minutes” display will be blinking. Turn the JOG WHEEL until
the desired amount of time is displayed (up to 9 minutes). Next push an ARROW button and
the “seconds” display will be blinking. Turn the JOG WHEEL until the desired amount of
seconds (up to 59) is displayed. If you want to change the minutes push an ARROW button
again.
Once the desired ON TIME is displayed, push the ENTER button for the OFF TIME
setting. This refers to the amount of time between bursts of fog. The “minutes” display will be
blinking. Turn the JOG WHEEL until the desired amount of time is displayed (up to 59
minutes). Next push an ARROW button and the “seconds” display will be blinking. Turn the
JOG WHEEL until the desired amount of seconds (up to 59) is displayed. If you want to
change the minutes push an ARROW button again.
Once the OFF TIME is set, push the ENTER button and the LCD will display “SET
DMX?”. Answer “YES” if you wish to set a DMX channel (see below DMX MODE) or
“NO” if you do not. Push the ENTER button. The display will read “SAVE SETTINGS?”.
If you want to keep the timer settings push an ARROW button until “YES” is blinking then
push the ENTER button. If you do not want to keep the timer settings, push an ARROW
button until “NO” is blinking and then push the ENTER button. The LCD will return to the
“SET TIMERS” display. New times can now be entered. Once the settings are saved and the
Operation Menu is displayed, the timer function can be turned on by pushing the TIMER
button on the remote. The yellow LED over the
TIMER button will light indicating that the
Delta is in timer mode. When timers are no longer required, simply push the TIMER button
again. To adjust the volume in the TIMER MODE, turn the JOG WHEEL to the desired fog
volume.
Note: When “YES” is chosen in the “SAVE SETTINGS” submenu, the memory in the
DIGITAL/DMX REMOTE CONTROL
will remember the settings even when the machine is
turned off or disconnected from a power source.
11. DMX MODE