Specifications

165
NLUO PMC CONTRACTOR
SIGNATURE AND SEAL SIGNATURE AND SEAL SIGNATURE AND SEAL
(j) The I.C. switches and Distribution Fuse Boards shall be provided with neat lettering in block letters with paint for
identification of the I.C. switches and for the points connected to each fuse way of the D.B.’s for which no extra payment
will be admissible.
(k) Completion Tendered Drawings.
The contractor shall be required to submit along with Final bill, the under noted Tendered Drawings on tracing papers,
along with three copies of Ammonia print each.
(l) Plan (as per structural Tendered Drawing) of each floor (not less than 1 : 100 metric scale) showing :
(i) Locations of Main Switch Board, Distribution boards (with the circuit numbers controlled by them).
(ii) The runs of mains and sub-mains.
(iii) Location of lights, fans wall sockets, other power consuming devices together with type of fittings and fixtures
including circuit numbers.
(iv) Position of lighting conductors and route of running conductor.
(v) Position of Earthing Stations for light and power and Lighting conductor installation.
and giving the following information’s on the plans :
(a) Name of work with job no. Accepted Tender No.
(b) Date of completion.
(c) Name of the place.
(d) Name and signature of the Contractor.
(e) Scale of Tendered Drawings.
2. Schematic line layout diagram of each floor showing (i) layout and connections of Main and Sub-board, B.D.B. having
descriptions of the size, capacity, type and their numbers the system and the source of supply, (ii) Location, size, type, length
of main and sub main cables (iii) Loading of each B.D.B indications of phases, Departmental mark in each B.D.B. and
switchgear.
The Tendered Drawings shall be very neatly drawn and submitted properly without folding them.
3. Cable route should be marked on site plan with measurements from permanent structures.