Specifications

78
NLUO PMC CONTRACTOR
SIGNATURE AND SEAL SIGNATURE AND SEAL SIGNATURE AND SEAL
9. Protection => IP 44
10. Tube Diameter => 59 mm.
11. Voltage => 1.8 KV/1S etc complete as per the given Tendered Drawing and as per the direction of Engineer-in-Charge
5.0 FLUSH DOOR:
Supplying and fixing BWR grade Flush Doors shutter 30mm thick with block wood construction and ply veneering on both side
conforming to IS : 2202.
(i) 38mm thick Flush Doors shutter finished with decorative veneer :-
The Flush door shall be finished with 4mm thick decorative veneer both sides including melamine polish, groove design and 38
X 6 mm teakwood beading all round the edges etc., all complete and as per the Tendered Drawing and direction of Engineer-in-
charge.
(ii) 32mm thick Flush Doors shutter partly glazed finished with decorative laminate :-
The Flush Door shutter shall be finished with 1mm thick decorative laminate of approved shade (conforming to I.S : 2046-1995)
on both sides including 32 X 6 mm teakwood beading all round the edges and 6mm thick glass to be inserted as per Tendered
Drawing etc., all complete as per the Tendered Drawing and direction of Engineer-in-charge. Necessary groove design to be
provided as per Tendered Drawing.
(iii) 32mm thick Flush Doors shutter finished with decorative laminate :-
The Flush Door shutter shall be finished with 1mm thick decorative laminate of approved shade (conforming to I.S : 2046-1995)
on both sides including 32 X 6 mm teakwood beading all round the edges as per Tendered Drawing etc., all complete as per the
Tendered Drawing and direction of Engineer-in-charge. Necessary groove design to be provided as per Tendered Drawing.
.
(iv) 35mm thick Flush Doors shutter finished with decorative veneer & Decorative laminate :-
The Flush door shall be finished with 1mm thick decorative laminate of approved shade (conforming to I.S : 2046-1995) on one
side and 4mm thick decorative veneer on another side including melamine polish, groove design and 35 X 6 mm teakwood
beading all round the edges etc., all complete and as per the Tendered Drawing and direction of Engineer-in-charge.