Specifications

80
NLUO PMC CONTRACTOR
SIGNATURE AND SEAL SIGNATURE AND SEAL SIGNATURE AND SEAL
operator profile, lock with 10 mm plain toughened glass for complete elevation - 2 moving panels. UPS of 750 VA shall be provided
by others, which will give power backup of 20 min. only & if the duration of power cut to the operator is more than 30 min. then
separate arrangement needs to be done for the same as automatic operator require uninterrupted stabilized power supply. The above
work complete in all respect as per approved Tendered Drawings and to the satisfaction of engineer-in-charge / architect consultant.
8.0 WALL CLADDING:
Supplying and fixing of wall cladding with 12mm. ply fixed to 19mm. Block board frame of 600 x 600 mm interval surface
finished with 4.0 mm thick veneer with melamine polish of approved shade and teakwood beading as per Tendered Drawing
and design etc all complete as per instruction of Engineer in – charge.
Supplying and fixing of wall cladding with 12mm. ply fixed to 19mm. Block board frame of 600 x 600 mm interval surface
fixed with 1mm. laminate of approved shade and teakwood beading as per Tendered Drawing and design etc as per instruction
of Engineer in - charge.
9.0 METAL LAM STRIPS:
Providing & fixing metal laminate of thickness 1mm over wall cladding base with 10mm groove in between as per Tendered
Drawing ,design and instruction of Engineer in - charge.
10.0 FALSE CEILING WITH GYPSUM BOARD:
(A) Providing and fixing of false ceiling of 12.5 mm. thick tapered edge gypsum board fixed to the G.I. frame work consist of
angle cleats at 1200 mm. centre to centre fixed to ceiling with dash fastner with bolt to the 25 X 25 X 0.5 mm. of required
length other side of the hanger fixed to G.I channel of 45 X 15 X 0.9 mm. running at 1200 mm. centre to centre with ceiling
section at 450 mm. centre to centre fixed in perpendicular to the intermediate G.I channel with connection clips the perimeter
channel fixed to the wall / partition with screws. The tapper edge of the gypsum board finished with recommended filler and
paper tape finishes and two coats of primer with three coats of acrylic emulsion paint of approved shade (roller finish)
suitable for gypsum board as per manufacturers specification and also including the coat of making openings for light fittings,
grills, diffusers, cutouts made with frame of perimeter channels suitably fixed all complete as per Tendered Drawing and
specification and direction of the PMC.