CRYSTALVIEW™ USB2 CATx USB 2.0 / VIDEO EXTENDER INSTALLATION AND OPERATIONS MANUAL 3 10707 Stancliff Road Houston, Texas 77099 Phone: (281) 933-7673 WWW.ROSE.
.
LIMITED WARRATY Rose Electronics warrants the CrystalView USB2 to be in good working order for one year from the date of purchase from Rose Electronics or an authorized dealer. Should this product fail to be in good working order at any time during this one-year warranty period, Rose Electronics will, at its option, repair or replace the Unit as set forth below. Repair parts and replacement units will be either reconditioned or new. All replaced parts become the property of Rose Electronics.
TABLE of CONTENTS Contents Page Disclaimer .................................................................................................... 1 System introduction ..................................................................................... 1 Features ................................................................................................ 2 Cable Requirements ............................................................................. 2 Compatibility ...................................
INTRODUCTION Disclaimer While every precaution has been taken in the preparation of this manual, the manufacturer assumes no responsibility for errors or omissions. Neither does the manufacturer assume any liability for damages resulting from the use of the information contained herein. The manufacturer reserves the right to change the specifications, functions, or circuitry of the product without notice.
Features Supports USB 1.1 (low/full speed) and USB 2.0 (high-speed) devices Extend single, dual, or quad video and USB 1.1 or 2.0 peripherals up to 150 ft (50m) from a USB 2.
MODELS CrystalView USB2 Models Transmitter Receiver Single Video Model Transmitter Receiver Dual Video Model Transmitter Receiver Quad Video Model Connectors Transmitter VGA IN LINK x LINK USB LINK HOST Audio POWER HD15M RJ45F RJ45F USB TYPE B 3.5mm +5VDC Receiver VGA OUT LINK x LINK USB USB DEVICES Audio AUX / KB POWER HD15F RJ45F RJ45F USB TYPE A 3.
INSTALLATION Installation Please refer to the safety section first before proceeding with any installation or configuration or the CrystalView USB2. It is recommended that the following installation procedure be followed to assure proper cable connections, power up sequencing, and accurate monitor DDC table information is obtained from the connected video monitors. Also all equipment should be powered off until all cabling is connected. Figure 1 shows a typical configuration using the single video model.
Transmitter installation Refer to Figure 1 for transmitter installation 1. Locate the transmitter near the host computer 2. Connect the power adapter to the transmitter (Do not apply power) 3. Connect a video extender cable from the transmitters HD15M connector to the host computers HD15F video output port and an audio cable (optional) 4.
OPERATING PROCEDURES Operating procedure Operation of your system is no different than having your keyboard, monitor, mouse, speakers, and USB devices connected directly to a PC. The only difference is they can be up to 150 feet away. You can operate your system normally, programs can be executed, maintenance can be performed, and any operation normally performed can be done with no derogation in video quality and performance. The video signal on all models can be fine tuned using simple keyboard commands.
TROUBLESHOOTING Troubleshooting The troubleshooting section is used as a guide to understanding the capabilities of the ViewLink CATx and for general troubleshooting. If you have any problems or questions concerning the installation, operation or usage of the ViewLink CATx that is not covered in this manual, please contact Rose Electronics for technical support.
MAINTENANCE and SERVICE Maintenance and Repair This Unit does not contain any internal user-serviceable parts. In the event a Unit needs repair or maintenance, you must first obtain a Return Authorization (RA) number from Rose Electronics or an authorized repair center. This Return Authorization number must appear on the outside of the shipping container. See Limited Warranty for more information.
SAFETY Safety The CrystalView USB2 USB and video extender has been tested for conformance to safety regulations and requirements, and has been certified for international use. Like all electronic equipment, the CrystalView USB2 should be used with care. To protect yourself from possible injury and to minimize the risk of damage to the Unit, read and follow these safety instructions. Follow all instructions and warnings marked on this Unit.
APPENDICES Appendix A. General Specifications Part Number Description CRK-1VH4U2TP-150 Single Video / USB 2.0 CRK-2VH4U2TP-150 Dual Video / USB 2.0 CRK-4VH4U2TP-150 Quad Video / USB 2.0 CRK-1VP4U2TP-150 Single Video / USB 2.0 AUX – PS/2 CRK-2VP4U2TP-150 Dual Video / USB 2.0 AUX – PS/2 CRK-4VP4U2TP-150 Quad Video / USB 2.0 AUX – PS/2 TFR-05D500FSUB-2.
10707 Stancliff Road Houston, Texas 77099 Phone: (281) 933-7673 WWW.ROSE.