Specifications

INSTALLATION

CRYSTALVIEW USB2 INSTALLATION AND OPERATINS MANUAL

Installation

Please refer to the safety section first before proceeding with any

installation or configuration or the CrystalView USB2. It is recommended

that the following installation procedure be followed to assure proper cable

connections, power up sequencing, and accurate monitor DDC table

information is obtained from the connected video monitors. Also all

equipment should be powered off until all cabling is connected.

Figure 1 shows a typical configuration using the single video model. The

dual and quad video models are installed and configured in the same

manor with 2 or 4 PC video ports connected to the transmitter unit and 2 or

4 video monitors connected to the receiver unit.

USB 2.0 Host PC Monitor < < < USB Devices > > >

Figure 1 - Typical Configuration

NOTE: The maximum length of the Category 5 UTP cable must not

exceed 50m. If Cat-5 patch cable is used, total length should not

exceed 10m (EIA/TIA-568 specification).

NOTE: All references to Category 5 UTP solid core cable in this document

represent the minimum requirement. Category 5E, Category 6 or

better UTP or STP cable may be substituted.

NOTE: All units in the system should be tied to a common

EARTH ground for proper operation

Power Up to 150 feet of CAT5 cable Power

Adapter

Transmitter Receiver

Up to 150’ CAT5 cable

Video Cable

USB Cable