CrystalLink USB 2.0 CAT5 USB CAT5 Extender INSTALLATION AND OPERATIONS MANUAL Part Number CLK-4U2TP-100M 10707 Stancliff Road Houston, Texas 77099 Phone: (281) 933-7673 WWW.ROSE.
LIMITED WARRANTY ® Rose Electronics warrants the CrystalLink™ USB 2.0 CAT5 to be in good working order for one year from the date of purchase from Rose Electronics or an authorized dealer. Should this product fail to be in good working order at any time during this one-year warranty period, Rose Electronics will, at its option, repair or replace the Unit as set forth below. Repair parts and replacement units will be either reconditioned or new. All replaced parts become the property of Rose Electronics.
FCC/IC STATEMENTS, EU DECLARATION OF CONFORMITY FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO-FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses and can radiate radio frequency energy and if not installed and used properly, that is in strict accordance with the manufacturer’s instructions may cause interference to radio communication.
TABLE of CONTENTS Contents Page # Disclaimer ...................................................................................................... 1 System introduction ....................................................................................... 1 Features ......................................................................................................... 2 Package contents ..........................................................................................
INTRODUCTION Disclaimer While every precaution has been taken in the preparation of this manual, the manufacturer assumes no responsibility for errors or omissions. Neither does the manufacturer assume any liability for damages resulting from the use of the information contained herein. The manufacturer reserves the right to change the specifications, functions, or circuitry of the product without notice.
Features Supports USB 1.1 (low and full speed) and USB 2.0 (high-speed) Extends USB devices up to 330 feet (100m) over CAT5 or better cable Four USB ports on the receiver unit +5VDC Power adapter for the Transmitter and Receiver Standard USB hubs can be used to increase the number of connected USB devices up to 14.
MODEL CrystalLink USB 2.
Receiver Indicator LEDs Power Link Host Activity Connectors Power - 5V DC USB – (4) Type A Link - RJ45F Power LED (Blue) On when power is supplied from the computer’s USB port, Off when no power is supplied Host LED (Green) On when installed properly Link LED (Green) On when a link between the transmitter and receiver is established, Off when no link is detected Activity LED (Amber) Blinks when data is transmitted Cables The only cable(s) needed are industry standard CAT5 or better cable(s).
INSTALLATION Figure 1 outlines the basic installation of the CrystalLink USB 2.0 CAT5 extender. The installation steps below are a guide to properly install the units and cabling. Transmitter Receiver CAT5 Cable Figure 1. Installation USB 1.1 or 2.0 peripherals Before you install the CrystalView USB 2.
Operating Instructions Operating your CrystalLink USB 2.0 extender is no different than having your USB peripherals directly connected to your computer’s USB port. Any compatible USB 1.1 or 2.0 device can be totally controlled and operated normally with no special configuration or commands. USB printers, digital cameras, scanners, or any compatible USB 1.1 or 2.0 device will function properly.
TROUBLESHOOTING Troubleshooting Guide The troubleshooting section is used as a guide to understanding the capabilities of the CrystalLink USB 2.0 CAT5 extender and for general troubleshooting. If you have any problems or questions concerning the installation, operation or usage of the CrystalLink USB 2.0 CAT5 extender that is not covered in this manual, please contact Rose Electronics for technical support.
SAFETY Safety The CrystalLink USB 2.0 CAT5 extender has been tested for conformance to safety regulations and requirements, and has been certified for international use. Like all electronic equipment, the CrystalLink USB 2.0 CAT5 extender should be used with care. To protect yourself from possible injury and to minimize the risk of damage to the Unit, read and follow these safety instructions. Follow all instructions and warnings marked on this Unit.
Safety and EMC Regulatory Statements Safety information Documentation reference symbol. If the product is marked with this symbol, refer to the product documentation to get more information about the product. WARNING A WARNING in the manual denotes a hazard that can cause injury or death. CAUTION A CAUTION in the manual denotes a hazard that can damage equipment. Do not proceed beyond a WARNING or CAUTION notice until you have understood the hazardous conditions and have taken appropriate steps.
SERVICE Service Information Maintenance and Repair This Unit does not contain any internal user-serviceable parts. In the event a Unit needs repair or maintenance, you must first obtain a Return Authorization (RA) number from Rose Electronics or an authorized repair center. This Return Authorization number must appear on the outside of the shipping container. See Limited Warranty for more information.
APPENDICES Appendix A. General Specifications Max distance 330 feet (100 meters) over CAT 5 (or better) stranded or solid conductor cable USB device support High-speed devices (480 Mb/s) (USB 2.0) Full speed devices (12 Mb/s) (USB 2.0 & 1.1) Low speed devices (1.5 Mb/s) (USB 2.0 & 1.1) USB hub support Any single chain can include up to 4 USB hubs plus one Receiver USB host support EHCI (USB 2.0) and OHCI/UHCI (USB 1.1 Maximum USB devices Supported (Incl.
10707 Stancliff Road Phone: (281) 933-7673 Houston, Texas 77099 Internet: www.rose.