CrystalLink USB 2.0 Fiber USB Fiber Extender INSTALLATION AND OPERATIONS MANUAL Part Number CLK-4U2FM-500M CLK-4U2FS-10KM 10707 Stancliff Road Houston, Texas 77099 Phone: (281) 933-7673 WWW.ROSE.
LIMITED WARRANTY ® Rose Electronics warrants the CrystalLink™ USB 2.0 Fiber extender to be in good working order for one year from the date of purchase from Rose Electronics or an authorized dealer. Should this product fail to be in good working order at any time during this one-year warranty period, Rose Electronics will, at its option, repair or replace the Unit as set forth below. Repair parts and replacement units will be either reconditioned or new.
FCC/IC STATEMENTS, EU DECLARATION OF CONFORMITY FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO-FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses and can radiate radio frequency energy and if not installed and used properly, that is in strict accordance with the manufacturer’s instructions may cause interference to radio communication.
TABLE of CONTENTS Contents Page # Disclaimer ...................................................................................................... 1 System introduction ....................................................................................... 1 Features ......................................................................................................... 2 Package contents ..........................................................................................
INTRODUCTION Disclaimer While every precaution has been taken in the preparation of this manual, the manufacturer assumes no responsibility for errors or omissions. Neither does the manufacturer assume any liability for damages resulting from the use of the information contained herein. The manufacturer reserves the right to change the specifications, functions, or circuitry of the product without notice.
Features Supports USB 1.1 (low and full speed) and USB 2.0 (high-speed) Supports USB 2.0 and USB 1.1 host computer systems (EHCI / USB 2.0 – OHCI/UHCI USB 1.1) Extends USB devices up to 1640 feet (500m-Mulitmode model) or 6 miles (10 Km-Singlemode model). Four USB port on the receiver unit Standard USB hubs can be used to increase the number of connected USB devices (up to 14 devices, including 3 USB hubs.
MODEL CrystalLink USB 2.0 Fiber model Transmitter Indicator LEDs Power Link Host Activity Connectors Power* - 5V 0.
Receiver Indicator LEDs Power Link Host Activity Connectors Power - 5V DC USB - Type A Link – Fiber Duplex LC Power LED (Blue) On when power is supplied from the computer’s USB port, Off when no power is supplied Host LED (Green) On when installed properly Link LED (Green) On when a link between the transmitter and receiver is established, Off when no link is detected Activity LED (Amber) Blinks when data is transmitted Cables The only cable(s) needed are the fiber cables to connect the transmitt
TROUBLESHOOTING Figure 1 outlines the basic installation of the CrystalLink USB 2.0 Fiber extender. The installation steps below are a guide to properly install the units and cabling. Transmitter Receiver Fiber Cable Figure 1. Installation USB 1.1 or 2.0 peripherals Before you install the CrystalView USB 2.0 Fiber extender, it is recommended that you pre-plan you system layout, consisting of the placement of the computer, the routing of the fiber cabling, and the location of the USB device(s). 1.
SAFETY Operating Instructions Operating your CrystalLink USB 2.0 Fiber extender is no different than having your USB peripherals directly connected to your computer’s USB port. Any compatible USB 1.1 or 2.0 device can be totally controlled and operated normally with no special configuration or commands. USB printers, digital cameras, scanners, or any compatible USB 1.1 or 2.0 device will function properly.
TROUBLESHOOTING Troubleshooting Guide The troubleshooting section is used as a guide to understanding the capabilities of the CrystalLink USB 2.0 Fiber extender and for general troubleshooting. If you have any problems or questions concerning the installation, operation or usage of the CrystalLink USB 2.0 Fiber extender that is not covered in this manual, please contact Rose Electronics for technical support.
SAFETY Safety The CrystalLink USB 2.0 Fiber extender has been tested for conformance to safety regulations and requirements, and has been certified for international use. Like all electronic equipment, the CrystalLink USB 2.0 Fiber extender should be used with care. To protect yourself from possible injury and to minimize the risk of damage to the Unit, read and follow these safety instructions. Follow all instructions and warnings marked on this Unit.
Safety and EMC Regulatory Statements Safety information Documentation reference symbol. If the product is marked with this symbol, refer to the product documentation to get more information about the product. WARNING A WARNING in the manual denotes a hazard that can cause injury or death. CAUTION A CAUTION in the manual denotes a hazard that can damage equipment. Do not proceed beyond a WARNING or CAUTION notice until you have understood the hazardous conditions and have taken appropriate steps.
SERVICE Service Information Maintenance and Repair This Unit does not contain any internal user-serviceable parts. In the event a Unit needs repair or maintenance, you must first obtain a Return Authorization (RA) number from Rose Electronics or an authorized repair center. This Return Authorization number must appear on the outside of the shipping container. See Limited Warranty for more information.
APPENDICES Appendix A. General Specifications Max distance 1640 feet (500m) using 50/125µm Multimode 902 feet (275m) using 62.5/125µm Multimode 6 miles (10km) using 9.0 µm Singlemode USB device support High-speed devices (480 Mb/s) (USB 2.0) Full speed devices (12 Mb/s) (USB 2.0 & 1.1) Low speed devices (1.5 Mb/s) (USB 2.0 & 1.1) USB hub support Any single chain can include up to 4 USB hubs plus one Receiver USB host support EHCI (USB 2.0) and OHCI/UHCI (USB 1.1 Maximum USB devices Supported (Incl.
10707 Stancliff Road Phone: (281) 933-7673 Houston, Texas 77099 Internet: www.rose.
