CrystalView DVI Micro Extender Quick Start Guide CrystalView DVI Micro Fiber Extender
Limited Warranty Rose Electronics® warrants the CrystalView™ Extender to be in good working order for one year from the date of purchase from Rose Electronics or an authorized dealer. Should this product fail to be in good working order at any time during this one-year warranty period, Rose Electronics will, at its option, repair or replace the Unit as set forth below. Repair parts and replacement units will be either reconditioned or new. All replaced parts become the property of Rose Electronics.
FCC and EU Declaration of Conformity FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO-FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses and can radiate radio frequency energy and if not installed and used properly, that is in strict accordance with the manufacturer’s instructions may cause interference to radio communication.
Disclaimer While every precaution has been taken in the preparation of this manual, the manufacturer assumes no responsibility for errors or omissions. Neither does the manufacturer assume any liability for damages resulting from the use of the information contained herein. The manufacturer reserves the right to change the specifications, functions, or circuitry of the product without notice.
EDID Settings The factory EDID settings can be changed by the following procedure: 1. 2. 3. 4. 5. 6. 7. 8. 9.
Part Numbers CRK-T1DFMDM CRK-T1DFMDM/HDCP CrystalView DVI Micro Extender CrystalView DVI Micro Extender/HDCP Troubleshooting a) No display on the DVI monitor - Check if the PC power is on. - Check if connection to the computer and the monitor are correct. - Turn the PC power off and on again. b) Noise is shown on the screen. - Check the DVI connection. - Check the display resolution.